Search
Now showing items 1-10 of 65
Optimal siting and sizing of single SPV system in radial distribution network for loss reduction based on maximum power saving technique
(2016)
This paper presents the optimal placement of aSPV (Solar Photovoltaic) system in thedistribution system using the backward and forward sweep method based on the analytical maximum power saving technique for the maximum ...
Continuation load flow with a neuro fuzzy model of an induction motor for voltage stability analysis
(2010)
This paper uses the concept of the continuation power flow analysis used in voltage stability
Analysis for control the power in large systems. It uses the PV curves to find the knee point of a certain bus. A neuro fuzzy ...
Protection of Terminal Distribution Transformers: A Case Study of Kenya Power
(IEEE, 2018)
The paper presents and analyses the main causes of high failure rate of Terminal Distribution Transformers (TDTs) in Kenya. These transformers are the most susceptible to faults emanating from lightning strikes and associated ...
MPPT of a standalone wind energy conversion system using magnetostrictive amorphous wire speed sensor and fuzzy logic
(2014)
This paper details the design and implementation of a Fuzzy Logic based controller for Maximum Power Point Tracking (MPPT) of a case study standalone wind energy
conversion system(WECS). A magnetostrictive amorphous wire ...
Profit based unit commitment in deregulated electricity markets using a hybrid lagrangian relaxation - particle swarm optimization approach
(2017)
In deregulated electricity markets, individual generation companies (GENCOs) carry out independent unit commitment based on predicted energy and revenue prices. The GENCOs unit commitment strategies are developed with the ...
Design optimization of a renewable hybrid energy system
(2013)
This paper proposes the optimal design of a renewable hybrid energy system consisting of solar, wind energy with battery storage suitable for application in remote areas. The study investigates the possibility of reducing ...
Optimal under frequency load shedding using CUCKOO search wirh levy flight algorith for frequency stability improvement.
(2015)
Frequency stability in a power system is very important as it determines the synchronous speed of electrical machines. Therefore it should remain within acceptable limits even when the system is disturbed. In order to ...
Comparison of aggregation methods of induction motor models for transient stability load modeling
(2010)
This paper focusses on the comparison of the aggregation methods of multiple induction motors (IM) connected in parallel on the same bus into a single equivalent model using the no-load and locked-rotor and transformer ...
Reactive Power-Voltage-Based Voltage Instability Sensitivity Indices for Power Grid With Increasing Renewable Energy Penetration
(2020-05)
In this work, a reactive power-voltage (QV)-based framework to evaluate the voltage instability sensitivities of power system buses to increase in renewable energy (RE) penetration has been developed using two sensitivity ...
Review of HVDC Circuit Breakers Topologies
(2017-05)
Voltage Source Converter-High Voltage Direct Current (VSC-HVDC) is the most efficient and reliable method for electrical power transmission over long distances. The greatest challenge with VSC-HVDC system is that short-circuit ...